Hi, I managed to burn out an easydriver v4.5. I didnt get it to work directly on the parallel port on my computer. So I am looking for another test setup to experiment with linuxcnc. It would have to be connected directly to the parallel port. I am asking just to make sure that this is possible to connect to linuxcnc parallel port. Drivers and motors: Can these drivers be directly controlled to the parallel port? Or would I need following breakout board to get it to work.?

Peugeot 206 1.4 Hdi Haynes Manual there. Breakout board: Thanks for your opinions.

HI, anybody knows if is possible to use two parallel ports with a emc2, one will be used to control step motors and another will be used as I/O by classic. Linuxcnc - LinuxCNC controls CNC machines. It can drive milling machines, lathes, 3d printers, laser cutters, plasma cutters. = Parallel Port Driver. Strictly to the point. Assuming: -You have a working linuxcnc install with a compatible parallel port -You have wired Bread-Out Board V5 to the motor drivers so you. Yamaha Dsp Factory Ds2416 Drivers.